A SERVICE OF

logo

Open as PDF
next previous
Bobbin Winding
oRemoving bobbin case
Remove the extension table from the machine by pulling itto
the left_ Open the shuttle coverOby pulling down the
embossed part on the left of the cover,
Raise the needle to its highest position by rotating the
handwheel toward you
(_) Shuttle cover
(_) Bobbin case
To remove the bobbin case(_)from the shuttle, pull open the
latch of the bobbin case, Pull the bobbin case straight out of
the shuttle,
, Bobbin winding
[] Release the clutch by pulling out the handwheel This
will stop the needle from moving while you wind the
bobbin
f
[]
k.
[] Draw thread from spool
[] Guide the thread around the thread guide
[] Thread through the hole in the bobbin from the inside to
the outside
[] Put the bobbin on the bobbin winder spindle
f
[]
[]
[]
18