. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-28 Preparing for Use with Mac
A. If there is an external SCSI terminator on an otherwise empty SCSI
connector on the last device, remove it.
B. If there is an external SCSI terminator between the end of a cable
and a SCSI connector on a device, remove the terminator, and
then reconnect the cable. (Later, if you remove the DCS 465
Camera Back cable from your Macintosh computer, remember to
replace this terminator.)
NOTE: If you have a Macintosh IIfx computer, you must use the appro-
priate SCSI terminator for that computer system (not supplied with the
DCS 465 Camera Back).
5. Select the SCSI cable with the 50-pin connector at one end and the
25-pin connector at the other end.
IMPORTANT: Use only the cable supplied with the DCS 465 Camera Back;
do not use a substitute cable.
25-pin Connector50-pin Connector
