Troubleshooting
www.kodak.com/go/support
57
Mode-dial-light indicator status
Picture is too light
or overexposed
■ Reposition camera to reduce the amount of available light.
■ Turn flash off (page 13).
■ Move so that the distance between you and the subject is within the
effective flash range (page 13).
■ To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator is green, press the Shutter
button completely down to take the picture.
■ Use P mode to adjust the exposure compensation.
Picture is not clear
■ To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator is green, press the Shutter
button completely down to take the picture.
■ Clean the lens (page 71).
■ Make sure camera is not in Macro AF mode if you are more than
24 in. (61 cm) from your subject.
■ Place the camera on a flat, steady surface or use a tripod, especially
in high-zoom settings or in low light.
If... Try one or more of the following
Mode dial light
does not turn on
and the camera
does not work
■ Turn on the camera (page 3).
■ Recharge the battery or install a new one (page 2).
■ Camera may have turned off automatically. Turn on the camera and
change the auto power-off setting (see page 36).
Mode dial light
blinks
■ Picture is being processed and saved to the camera. Camera is
operating normally.
■ Camera is connected. Camera is operating normally.
■ Recharge the battery or install a new one (page 2).
Mode dial light
glows steady
■ Shutter button is pressed halfway down. Focus and exposure are set.
Camera is operating normally.
■ Camera is operating normally.
If... Try one or more of the following
