10
Manual No. 701-186M 11/30/06
Land Pride
Assembly Instructions
Wiring Checks
1. Recheck your installation. Make sure:
a. All wiring is secured and out of the way of all
moving parts of the vehicle.
b. All wiring and components are away from heat
sources such as exhaust pipe and cylinder head.
c. All components of the relay system are located so
as not to interfere with the safe and normal
operation of the vehicle.
1. Do not connect the 10" red wire attached to the 40
amp breaker at this time. Connect the vehicle’s red
electrical wires to the battery’s positive post (+).
Tighten connection.
2. Connect vehicle’s black ground wires and the 36"
black relay wire to the battery’s negative post (-).
Tighten connection.
Test Tether Switch Control Circuit
1. Plug tether connector into the pin receptacle.
2. Turn ignition switch on (do not start engine).
3. Operate tether switch up and down. You should hear
a “click” at the relay when operating the switch to
either position. The winch should NOT run at this
time.
4. If you do not hear relay “clicks”, check for 12 volts on
the green wire extending from the switch. Ignition
switch must be in the on position.
5. Unplug tether from pin receptacle and store in glove
box or an alternate location for safe keeping.
IMPORTANT: Do not connect the short red wire
leading from the winch relay to the battery until after
the control circuit has been tested.
Test Rocker Switch Control Circuit
Refer to Figure 16 on page 8:
1. Turn the ignition switch tothe on position(do not start
engine).
2. Operate the rocker switch by pushing in at the top
and then at the bottom. You should hear a “click” at
the relay when you operate the switch to either
position. The winch should NOT run at this time.
3. If you do not hear the relay “clicks”, check for 12 volts
purple wire attached to the middle of the rocker
switch. Ignition switch must be in the on position.
Final Test With 10" Red Wire Connected
1. Once you have verified proper operation of the
control circuit, disconnect the black ground wires
from the battery’s negative post (-).
2. Connect 10" red wire extending from the 40 amp
circuit breaker to the battery’s positive post (+).
3. Reconnect the black ground wires to the battery’s
negative post (-).
4. Place your winch in “freespool” and pull out
approximately 3 feet of wire rope.
5. Correctly orient the rocker switch as shown in Figure
16 on page 8. Turn the ignition switch on and operate
the rocker switch to spool wire rope in:
a. Pushing at the top of the rocker switch should
cause the winch to spool in.
b. Pushing at the bottom of the rocker switch should
cause the winch to spool out.
6. Switch the green and brown wires at the rocker switch
if the winch does not operate correctly.
7. Once the rocker switch operates correctly, press it
into the “AUX” mounting panel.
