A SERVICE OF

logo

Open as PDF
next previous
8. Install the drive into the bay until it snaps into position.
Note: or If you are installing the adapter bracket, install the screws that secure
the bracket in the bay.
9. A hard disk drive requires two cables; a power cable that connects to the power
supply and a signal cable that connects to the system board.
v A parallel ATA hard disk drive requires a four-wire power cable.
v A serial ATA hard disk drive requires a five-wire power cable.
The steps to connect a drive are different depending on the type of drive you are
connecting. Use one of the following procedures for your drive connection.
Chapter 1. Installing options 19