5. Carefully lift and position the computer upside down as shown in 6.
6. Pivot the cover-release button 1 on the rear of the computer and then raise
the cover as shown.
Installing internal options
Important
Read “Handling static-sensitive devices” on page 4 before opening the
computer cover.
Installing memory
Your computer has two slots for installing SODIMMs (small outline dual inline
memory modules) that provide up to a maximum of 4 GB of system memory.
When installing memory modules, the following rules apply:
v Use 1.8 V, 200-pin DDR3 SDRAM (double data rate 3 synchronous dynamic
random access memory).
v Use 1 GB or 2 GB memory modules in any combination up to a maximum of 4
GB.
Note:
If there is an available memory slot, continue with installing a memory
module. To replace a memory module, go to “Replacing a memory module” on
page 24.
This section provides instructions on how to install a memory module.
1. Open the computer cover. See “Opening the cover” on page 11.
2. Locate the memory slots. See “Identifying parts on the system board” on page
9.
Figure 5. Opening the computer cover
12 Hardware Installation and Replacement Guide
