Replacing a memory module
Attention
Do not open your computer or attempt any repair before reading the “Important safety
information” in the Safety and Warranty Guide that was included with your computer for
the computer. To obtain copies of the Safety and Warranty Guide, go to
http://www.lenovo.com/support.
This section provides instructions on how to replace a memory module.
Nota: Your computer has support for two memory modules.
1. Remove the computer cover. See “Removing the cover” a pagina 9.
2. Remove the bezel and drive bay assembly. See “Accessing system board
components and drives” a pagina 10.
3. Remove any parts that might prevent access to the memory connectors.
4. Remove the memory module being replaced by opening the retaining clips as
shown.
5. Position the replacement memory module over the memory connector. Make
sure that the notch 1on the memory module aligns correctly with the
connector key2 on the system board. Push the memory module straight
down into the memory connector until the retaining clips close.
Figura 33. Removing the memory module
Figura 34. Installing the memory module
Capitolo 3. Installing options and replacing hardware 27
