9. Slide the new hard disk drive into the hard drive cage until it snaps into
position
10. Install the hard drive cage into the chassis until it snaps into position
underneath the metal tab. Make sure that the hard drive cage is secure in the
chassis.
11. Connect the signal and power cables to the rear of the new hard disk drive.
12. Go to Chapter 4, “Completing the parts replacement,” on page 47.
Replacing an optical drive
Attention
Do not open your computer or attempt any repair before reading the “Important safety
information” in the Safety and Warranty Guide that was included with your computer. To
obtain a copy of the Safety and Warranty Guide, go to the Support Web site at
http://www.lenovo.com/support.
This section provides instructions on how to replace an optical drive.
1. Remove the computer cover. See “Removing the cover” on page 12.
2. Disconnect the signal and power cables from the rear of the optical drive.
Figure 27. Installing the secondary hard disk drive and drive cage
34 Hardware Installation and Replacement Guide
