36 Optional Equipment (for qualified installers only)
Travis Industries 100-01142 4050114
Blower (part # 99000154)
WARNING: Turn the gas control valve to off and make sure the appliance has fully cooled prior to
conducting service.
WARNING: This appliance is equipped with a three-prong (grounding) plug for your protection
against shock hazard and should be plugged directly into a properly grounded three-
prong receptacle. Do not cut or remove the grounding prong from this plug.
1 Slide the thermodisk into the holder underneath the firebox.
Snap Disk Bracket
(attached to stove)
Snap Disk
2 Attach the blower following the directions below.
Slide the fan mounting plate into
the slot on each of the rubber
grommets.
Fan Mounting Bracket
(attached to stove)
Rubber Grommet
(with spacer)
Nut
Slide the rubber grommets (with spacers inserted
inside) onto the fan mounting plate and attach
using the included washers and nuts.
Blower Mounting Bracket
11/32" Nutdriver
Washer
c
Attach the grommets (with spacers) to
the right side fan mounting bracket with
the included nuts and washers.
a
b
