A SERVICE OF

logo

1. PLC Development Environment Using GX Developer
1.3 Developing PLC Programs
- 17 -
1.3.5 Writing the PLC Program to the CNC
The following indicates how to write ladders from GX Developer to the CNC (especially the
restrictions and C64 series-specific operations).
(1) Operation procedure
Perform the following operation from GX Developer to start the operation screen.
[Online] [Write to PLC]
On the following screen, choose the ladder file to be written from the [File selection] tab and click
[Execute].
You can command RUN/STOP of the PLC using [Remote operation] under [Related functions].
(Note) As [Target memory], only [PLC RAM/Device memory] is valid.
Do not set the other tabs ([Device data], [Program], [Common], [Local]) than [File
selection].