1. LIST OF ALARMS
1.1 Operation Alarm
I - 7
Error No. Details Remedy
1030
Synchronization mismatch
Different M codes were commanded in
the two systems as the synchronization
M codes.
Synchronization with the "!" code was
commanded in another system during M
code synchronization.
Synchronization with the M code was
commanded in another system during
synchronization with the "!" code.
• Correct the program so that the M codes
match.
• Correct the program so that the same
synchronization codes are commanded.
1031
The C axis selection signal was changed
when multiple C axes could not be
selected.
An axis that cannot be controlled as the
multiple C axes selection was selected.
• Check and correct the parameters and
program.
1032
Tap return spindle selection illegal during
multi-spindle
Tap return was executed when a
different spindle was selected. Cutting
feed will wait until synchronization is
completed.
• Select the spindle for which tap cycle was
halted before the tap return signal was
turned ON.
1033
Tool-spindle Synchronization IB (G51.2)
cutting interlock
Cutting feed will wait until
synchronization is completed.
• Wait for synchronization to end.
1034
Cross machining command illegal
Cross machining control exceeding the
number of control axes was attempted.
Cross machining control with duplicated
axis addresses was attempted.
• Check the parameter settings for cross
machining control.
1035
Cross machining control disable modal
Cross machining control was
commanded for a system in which cross
machining control is disabled as shown
below.
• During nose R compensation mode
• During pole coordinate interpolation
mode
• During cylindrical interpolation mode
• During balance cut mode
• During fixed cycle machining mode
• During facing turret mirror image
• Check the program.
