Manual mode operation
(1)
Set the f/stop you desire or turn the shutter speed/
mode
se
le
ctor dial to any of eleven numbered
setti
ng
s you desire, (Note that you cannot set the
dial between indicated settings.)
(2)
While looking through the viewfinder, depress the
shutter
release button halfway and check the
lighted LEDs
• The blinking LED(s) indicat
es
the shutter speed
selected by the FG's microcomputer to
match
the f /stop you have
set
• The lighted LED indicates the shutter speed
you
ha
ve set
(3)
If
one LED is blinking,
to
get the
correct
exposure
rotate the aperture ring and/or the shutter speed
dial so that both the blinking LED and the steadily
lighted
LED
are aligned and only one LED lights
up
steadily If two LEDs are blinking, rotate the
apertu
re
ring and/or shutter speed dial until one
L
ED
lights up steadily or the blinking LEDs
come
as
c
lo
se
as
possible to
it
: then make further fine
adjustments by rotating the aperture ring so that
only one LED lights up steadily
(4)
If
you wish to create intentional under- or over-
exposure, set either the aperture ring or shutter
speed
dial so that your selected shutter speed
is
displayed
in
the viewfinder either above or below
that s
rlecte
d
by
the
FG
,
36
Notes:
Shutter speed
selected by
FG's micro-
computer
Shutter speed
you have set
Both speeds
aligned and
only one LED
lights steadily;
correct
exposure
assured
1)
At the mechani
cal
settings
of
M90
and 8, the meter does
not function and no
LEOs are displayed,
2)
The
audio warning system does not function on manual
