Troubleshooting
F7
Technical Notes and Index
Monitor is blank.
• Camera is off.
• Battery is exhausted.
• Standby mode for saving power. Press the
power switch, shutter-release button, A
button, c button, or b (e movie-record)
button.
• When flash lamp blinks red, wait until flash
has charged.
• Camera and computer are connected via
USB cable.
• Camera and TV are connected via audio/
video cable.
• The monitor turns off, while the projector is
in operation.
23
22
23
54
72
72, E 21
80
Monitor is hard to read.
• Adjust monitor brightness.
• Monitor is dirty. Clean monitor.
98, E 64
F 5
Date and time of recording
are not correct.
• If camera clock has not been set, “Date not
set” indicator blinks with shooting and movie
recording. Pictures and movies recorded
before clock is set are dated “00/00/0000
00:00” or “01/01/2011 00:00” respectively. Set
the correct time and date from the Time
zone and date option in the setup menu.
• Check camera clock regularly against more
accurate timepieces and reset as required.
24, E 61
25, E 61
No indicators displayed in
monitor.
Hide info is selected for Photo info.
Select Show info.
98, E 64
Print date not available. Camera clock has not been set. 24, E 61
Date not appearing on
pictures even when Print
date is enabled.
The current shooting mode is one that does
not support Print date.
99, E 66
Screen for setting time
zone and date is displayed
when the camera is turned
on.
Clock battery is exhausted; all settings were
restored to their default values.
24, 25
Camera settings reset.
Problem Cause/Solution A
