Black plate (343,1)
Model "S35-D" EDITED: 2010/ 6/ 4
FOR Kro
¯
m MODELS
Use the following steps to mount the license
plate:
Before mounting the license plate, confirm that
the following parts are enclosed in the vinyl bag.
. License plate bracket
. J-nut 6 2
. Screw 6 2
. Screw grommet 6 2
1. Park the vehicle on flat, level ground.
2. Temporarily place the license plate bracket
while aligning points
*
A
of the front bumper
fascia with holes
*
B
in the license plate
bracket.
3. Confirm that points
*
A
and
*
B
are aligned.
4. Remove the license plate bracket.
5. Carefully drill two shallow pilot holes
*
A
using a 0.39 in (10 mm) drill bit at the
marked locations. (Be sure that the drill
only goes through the fascia, or da-
mage to the nut may occur.)
6. Insert grommets into the hole on the fascia.
7. Insert a flat-blade screwdriver into the
grommet hole to add a 908 turn onto the
part
*
C
.
8. Insert a J-nut into the license plate bracket
before placing the license plate bracket on
the fascia.
9. Install the license plate bracket with the
screws.
10. Install the license plate with bolts that are
not longer than 0.55 in (14 mm).
WARNING
. It is extremely dangerous to ride
in a cargo area inside the vehi-
cle. In a collision, people riding
in these areas are more likely to
be seriously injured or killed.
. Do not allow people to ride in
any area of your vehicle that is
not equipped with seats and
seat belts.
. Be sure everyone in your vehicle
is in a seat and using a seat belt
properly.
TERMS
It is important to familiarize yourself with the
following terms before loading your vehicle:
. Curb Weight (actual weight of your
vehicle) - vehicle weight including:
standard and optional equipmen t,
fluids, emergency tools, and spare tire
assembly. This weight does not in-
clude passengers and cargo.
. GVW (Gross Vehicle Weight) - curb
weight plus the combined weight of
passengers and cargo.
VEHICLE LOADING INFORMATION
Technical and consumer information 9-13
