12
RQT8038
Cassette tape – Play and record
Recording CDsRecording CDs
1
Insert the cassette to be recorded on.
"
"
Insert inside the
guides
Forward side
2
Press [CD 6] and then [STOP 7, –DEMO].
3
Press [0 OPEN/CLOSE] to insert the CD.
Press again to close.
4
Press [PLAY MODE] to select your desired mode
(refer page 7).
5
Press [¶REC/8] to start recording.
Recording programmed tracksRecording programmed tracks
1
Program the tracks you want (refer page 9).
2
Press [¶REC/8] to start recording.
Other basic operationsOther basic operations
To Action
erase a recorded
sound
1) Insert the cassette to be recorded on.
2) Press [TAPE 3] and then [CLEAR 7].
3) Press [¶REC/8].
stop recording Press [CLEAR 7].
stop recording
temporarily
1) Press [¶REC/8].
2) Press again to resume recording.
to record on the
other side of the
tape
Turn the cassette over and press
[¶REC/8].
Erasure preventionErasure prevention
The illustration shows how to remove the tabs to prevent
recording. To record on the tape again, cover as shown.
Side A
Tab for side ATab for side B
To re-record
Normal tape
Adhesive tape
Basic playBasic play
1
Press [OPEN 0] on top of the unit.
2
Insert a cassette.
"
"
Insert inside the
guides
Forward side
3
Close the lid by hand.
4
Press [TAPE 3] to start play.
To play the other side of the cassette, turn the cassette
over.
To Action
stop tape playback Press [CLEAR 7].
start one touch play
Press [TAPE 3] when the system is OFF
with the cassette loaded.
fast-forward and
rewind
Press [4/REW/4] or [3 /FF/¢] in the
stop mode.
TPS (Tape Program Sensor)TPS (Tape Program Sensor)
This function enables you to search the beginning of a track,
up to a maximum of 9.
Press [4/REW/4] or [3/FF/¢] during play.
Play resumes from the track found.
TPS may not function properly with:
• Short silent parts
• Noise occurs between tunes
• Silent parts found within tunes
Before recordingBefore recording
Preparation
Wind up the leader tape so that recording can begin
immediately.
• Use normal position tape.
• High position and metal position tape can be used, but this unit will
not be able to record or erase them correctly.
Recording the radioRecording the radio
1
Insert the cassette to be recorded on.
2
Tune to the required station (refer page 13).
3
Press [¶REC/8] to start recording.
/0%.
Top of the unit
Cassette lid
PM41_8038-2P.indd 12PM41_8038-2P.indd 12 2/22/05 5:25:13 PM2/22/05 5:25:13 PM
