24
RQT9778
To prevent the speakers from falling, it is recommended, as an additional
protection measure, to attach the speakers to the wall or table with a fall
prevention cord (hereafter “cord”).
≥ Consultation with a qualified installation specialist concerning the appropriate procedure when attaching to a concrete wall or a
surface that may not have strong enough support is recommended (>13, 17). Improper attachment may result in damage to
the wall and speakers, and personal injury.
≥ Use a cord that is capable of supporting over 10 kg (22.05 lbs) (with a diameter of about 1.5 mm (
1
/16q)).
≥ The speaker fall prevention measure is to minimize the possibility of damage and harm, but it does not completely guarantee
this effect.
≥ Keep the screws out of reach of children to prevent swallowing.
≥ Make sure that the slack of the cord is minimal.
≥ Depending on the placement of the speakers, the screwing position of the screw eye may differ.
Additional speaker fall prevention measures
When attaching the speakers horizontally
A Cord
§
B Screw eye C Wall
§ If the cord cannot be threaded through the holes, try bending the cord in 2 locations,
about 10 mm (
13
/32q) apart from the tip, at an angle of 45
o
(as
illustrated above).
SC-HTB770PPC_RQT9778-1P_mst.book Page 24 Tuesday, January 29, 2013 11:33 AM
