1/2
SIGNAL
INPUT LABEL
WOBBLING
SET UP
OFF
POWER MANAGEMENT
OFF
AUTO POWER OFF
OFF
STANDBY SAVE
OFF
(
SERIAL
)
ECO
OFF
OSD LANGUAGE ENGLISH
(
US
)
COMPONENT/RGB-IN SELECT
RGB
OFF
SCREENSAVER
32
Reduces power consumption
Press to select the menu to adjust.
Press to select “ON” or “OFF”.
On Off
Press to exit from SET UP.
•
POWER MANAGEMENT
: When this function is set to ON, it operates under the following conditions to turn the power
on or off automatically.
When no pictures are detected for 30 or so seconds during PC signal input:
→ Power is turned off (standby); the power indicator lights up orange.
When pictures are subsequently detected:
→ Power is turned on; the power indicator lights up green.
Notes:
• This function operates only during input from PC IN terminal.
• This function is effective when “SYNC” is set to “AUTO” and during normal viewing (one
picture screen).
• AUTO POWER OFF: Equipment power supply is turned OFF when there is no signal.
When this is set to ON, the power supply of the unit goes Off 10 minutes after the input
signals stop.
Note:
This function is effective during normal viewing (one picture screen).
• STANDBY SAVE: When this function is set to “ON”, serial communication is disabled during standby mode,
reducing the power consumption during standby.
To perform serial communication while in standby, set this function to “OFF(SERIAL)”.
However, the standby power consumption is greater than when it is set to “ON”.
• ECO: This function adjusts the brightness of the backlight to reduce power consumption.
OFF: This function does not operate.
ON: Backlight brightness is reduced.
SENSOR: The backlight brightness is automatically adjusted according to the viewing
environment.
Note:
When this function is set to “ON” or “SENSOR”, the “BACKLIGHT” setting in the PICTURE
menu is disabled.
1
2
3
