- 116 -
Remote recording
You can set timer programming events of this TV on the network equipment
(smartphone, etc.) from outside the home network.
●
Ensure the network connections and network settings are completed.
Network > Network connections
Network > Network settings
●
Set TV Anywhere to On.
Network > Network settings > TV Anywhere Settings
●
Additional information for the services may be found on the following
website.
http://panasonic.net/viera/support (English only)
= Note =
●
This function is not available when the TV is turned off with Mains Power
On / Off switch.
●
Depending on the network condition, this function may not be available.
Note
●
TV Guide may also be used to set timer event.
Watching > TV Guide > Timer Programming
●
Timer Programming can store up to 15 events.
●
Timer Programming only works reliably if correct time information is
received via the signal from the broadcaster or service provider.
●
For recording using Timer Programming, the TV must be either on or in
Standby. For reminders to be displayed, the TV must be on.
●
Depending on the progress of recording, analogue channel may not be
selected.
●
Recording an encrypted (copy-protected) programme may not be possible.
●
2 minutes before the start time, a reminder message may appear if you
are watching TV.
– To remove the message and start the programming, press OK.
– To cancel the programming, press EXIT.
●
LED will turn to orange in Standby mode if Timer Programming is set.
●
Reminder messages will remain displayed until one of the following
occurs:
– You press OK to view the programme or EXIT to cancel the reminder.
– The timer event that the reminder is set for ends.
