4βNon-Interactive Commands
Command Summary
SN0054614-00 K 4-17
Where:
The pairs <param name> <param value> and <param alias> <param value> can
be repeated to set multiple parameters in a single command.
Table 4-5 lists the driver configuration parameter names and aliases.
The following restrictions apply:
ξ Under Solaris, the driver configuration feature is disabled if you are using the
driver from the OS installation CDs (QLC driver).
ξ Under Linux, this feature is disabled if you are using the IOCTL or sysfs
(inbox) driver.
ξ Under Macintosh, the BindWWPN and BindPortID parameters are not
changeable; Mac supports only the BindWWPN parameter.
hba instance = Adapter instance number of an adapter port (use -g
command to find)
hba wwpn = World wide port name of the adapter
param name = Name of the parameters
param alias = Alias of the parameters
param value = New value of the parameters
Table 4-5. Driver Settings Parameters
Description
Parameter Name
<param name>
Alias
<param
alias>
Value
a
<param
value>
a
0 = Disabled, 1 = Enabled
Persistently bound target(s) only PersistentOnly PO 0, 1
Present persistently bound tar-
get(s) plus any new target(s) with
driver default
PersistentPlusNew PN 0, 1
Present targets with driver default
NewOnly
b
b
Driver parameter NewOnly (NO) is supported only with the failover driver. If you select a QLA22xx
adapter, all QLA22xx adapters on the host will use the same settings. If you select a 23xx adapter,
all 2G/4G adapters on the host will also use the same settings.
NO 0, 1
Bind devices by WWPN BindWWPN BW 0, 1
Bind devices by port ID BindPortID BP 0, 1
Table Notes
