31
Scanning Memory Channels
To set the HTX-242 to scan memory channels, press and release
MR
. Then press and hold
MR
for at least 1 second.
.
flashes, and
the HTX-242 scans memories that have the scan option turned on
(see “Enabling/Disabling Scanning for Memory Channels” on this
page). The HTX-242 stops when it encounters a transmission. It
resumes scanning according to the saved scan settings (see “Set-
ting the Scan Options” on Page 20). To resume scanning immedi-
ately, press
MHz
.
Clearing a Memory Channel
You can clear any memory channel except Memory Channel 1 and
the calling-frequency memory.
1. Tune to the memory channel you want to clear.
2. Hold
F
for at least 1 second.
FUNC
flashes.
3. Press
MR
. All settings are cleared from the memory channel.
Enabling/Disabling Scanning for Memory Channels
You can disable (lock out) individual memory channels, so the
HTX-242 does not stop on them when you scan memory channels.
1. Tune to the memory channel you want to enable or disable
for scanning.
2. Press
F
, then press
MR
.
3. Repeatedly press
▲
until the HTX-242 displays
Sn
and the
scan setting.
4. To enable scanning for the current channel, rotate
TUNE
, or
press
UP
or
DOWN
on the microphone, to select
on
.
To disable scanning for the current channel, rotate
TUNE
, or
press
UP
or
DOWN
on the microphone, to select
oFF
.
5. Press
MR
or PTT to save the setting.
Note:
Scanning stops if you press
MR or PTT.
