Using Two VCRs for Copying and Editing Tapes
Operating Instructions
ukfer t0 hookup 0” page 6.~
Use one
VCR as the playback VCR and the other as the recording VCR.
1. Turn on the TV and VCRs.
cation: The u”a”tho”zed
ri
2. Tune TV to the VCR viewing channel, either 3,4, or TV’s
video input.
mcor&ng of Lelevlslon
p’0grarn~ and other
3. If you have connected your VCR using Option A @age 6), tune recording
materialr may lnti”“ge the
VCR to channel 3 or 4 -the one selected on the back of the playback
VCR.
nghts of c&err.
If you have connected your VCR using Option B (page 6% press INPUT
on recording
VCR’s remote to select the line input. L appears in VCR’s
display panel.
4. Insert the tape you want to copy into playback VCR.
Insert a blank tape
with safety tab in place into recording VCR.
5. Press PLAY/PAUSE on
the playback VCR to play the tape. When you reach
the point on the tape or program where you want to begin copying, press
PLAY/PAUSE to pause the tape. If streaks appear, you may need to adjust
TRACKING.
6. Press RECORD, then PLAY/PAUSE on recording VCR.
7. Press PLAY/PAUSE buttons on both VCRs at the same time to begin
copying the tape.*
8. Edit out segments that you do not want to copy by pressing PLAY/PAUSE
on recording VCR to
stop copying the tape.
Then, locate the next segment
you want to copy on playback VCR by using F.FWD, REW, and
PLAY/PAUSE. Then press PLAY/PAUSE on the playback VCR to pause
the tape. Press PLAY/PAUSE at the same time on both VCRs to resume
copying.
9. Press STOP/EJECT on both VCRs when you are finished.
’ You may bun off the TV after
the recording has started as it does not have to
be on to copy a tape.
Using Dual Remote with AutoEditTM
Use
this VCR as the recording VCR and set it to respond to VCR2 on the remote
as
demikd on page 12.
Use your other compatible VCR as the playback VCR
which should respond to
VCR1
1. Follow steps 1 - 4 in “Operating Inshuctions” above.
2. Press VCR2 on remote to control recording VCR. Press
REC/XPR, then
PAUSE, to put
recording
VCR in pause mode.
3. Press VCR1 on remote to control
playback VCR.
,
4. Use
PLAY, F.FWD, and REW, to locate the point where you want to begin
copying. Press PAUSE while VCR is playing to put playback VCR in pause
mode.
5. Press EDIT on
remote;
the VCRs will begin copying.
6. Press EDIT again when you want to stop the tape from copying.
7. Repeat steps 4 - 6 as needed.
8. Press VCRl, STOP, then VCR2, STOP, when you are finished.
26
ml
1
