When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
Always wear safety goggles or safety glasses with side
shields during tool operation. If operation is dusty, also
Before inspecting, cleaning, or servicing the machine,
shut off engine, wait for all moving parts to stop, and
disconnect spark plug wire and move it away from spark
or disconnect from power supply
these instructions can result in serious personal injury or
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or de-
stroy plastic which may result in serious personal injury.
You can often make adjustments and repairs described here.
For other repairs, have the tool serviced by an authorized
Replace blades that are damaged or worn.
Stop the engine and remove the spark plug wire or dis-
connect from the power supply.
Align the slot in the upper flange washer and gear case
with the slot in the flange; place the holding pin through
all three slots to secure in place.
Using a 1/2 in. socket wrench, turn the blade nut clock-
Remove the old blade from the edger shaft.
Clean debris from the edger shaft and flange washers.
Center the new blade on the upper flange washer, mak-
ing sure the blade sits flat.
Install the lower flange washer with the cupped hole away
Install the blade nut onto the edger shaft.
Using a 1/2 inch socket wrench, turn the blade nut coun-
terclockwise onto the edger shaft and tighten securely.
Always make sure the blade is correctly installed
securely fastened before each use.
