This product requires assembly.
Carefully remove the items from the box. Make sure that
all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
If any parts are damaged or missing, please call
1-800-242-4672 for assistance.
If any parts are damaged or missing, do not operate
this tool until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
JOINING THE POWER HEAD TO THE EDGER
Never attach or adjust any attachment while power head
is running. Failure to stop the engine and disconnect the
spark plug wire or disconnect from power supply may
cause serious personal injury.
The edger attachment connects to the power head by means
Loosen the knob on the coupler of the power head shaft
and remove the end cap from the attachment shaft.
Push in the button located on the edger attachment. Align
the button with the guide recess on the power head cou-
pler and slide the two shafts together. Rotate attachment
shaft until button locks into the positioning hole.
If the button does not release completely in the
positioning hole, the shafts are not locked into place.
Slightly rotate from side to side until the button is locked
Tighten the knob securely.
Be certain the knob is fully tightened before operating
equipment. Check it periodically for tightness during use
REMOVING THE ATTACHMENT FROM THE
To remove or change the attachment:
Push in the button and twist the shafts to remove and
