Page 6 of 12 2475SDB - Rev: 1/21/2014 7:58 AM
INSTEON Scenes
Scene Definition: One or more INSTEON devices that respond to an INSTEON controller. When the
scene is activated (turned “on”), all devices return to the states they were at when the scene was
programmed.
Adding In-LineLinc to a Scene as a Responder
1) Use the On and Off button on In-LineLinc to set the load to the state you wish to activate from the
controller (turn it on if you wish it to be on when the controller activates the scene, etc.)
2) Press & hold the scene controller button until it beeps
1
3) Press & hold the Set button on In-LineLinc until it double-beeps
In-LineLinc's Status LED will flash once and then turn on steady
Controller will (Beep)-(Beep)
2
and its LED will stop blinking
4) Confirm that scene addition was successful by tapping On then Off on the controller’s scene button
The In-LineLinc will respond appropriately
Removing In-LineLinc from a Scene as a Responder
If you are going to discontinue using In-LineLinc, it is very important that you remove it from all of its
scene controllers. Otherwise, the controllers will retry commands repetitively, creating network delays.
1) Press & hold the controller’s scene button until controller beeps
3
2) Press & hold the controller’s scene button until controller beeps again
3
3) Press & hold the Set button on In-LineLinc until it double-beeps
The In-LineLinc Status LED will flash once and then turn on bright if the load if off or dim if the
load is on
4) Confirm that Unlinking was successful by tapping the button you just Unlinked from on the controller
In-LineLinc will no longer respond
1
If the controller does not have a beeper, wait until its LED begins blinking
2
Most models
3
For devices without beepers hold until its LED begins blinking (this may take 10+ seconds)
