Adjustment Using the Menus
22
REMOTE menu
POWER SAVING Sets the power saving mode “ON”
or “OFF”. When set to “ON”, the
monitor goes into power saving
mode if no signal is input for about
one minute.
COMPUTER DETECT The appropriate preset memory is
set for the signal from DVI and
HD15 input connector. Select
“PRESET1” for the standard PC
signal. Select “PRESET2”,
“PRESET3”, “PRESET4” or
“PRESET5” when the PC signal is
not standard (on page 29).
The preset memory is set for each
input connector of DVI and HD15.
AUTO CHROMA/
PHASE
Adjusts color intensity (CHROMA)
and tones (PHASE).
• AUTO ADJ VALUE: Selects
“ON” or “OFF” of the Auto
adjustment. When set to
“OFF”, this parameter is
reset to the factory setting.
When set to “ON” the
automatically adjusted value
is enabled.
• START: Display the color bar
signals (Full/SMPTE/EIA)
on the screen and press the
ENTER key. The auto
adjustment function starts.
After the adjustment is done
correctly, the AUTO ADJ
VALUE is automatically set
to ON.
The auto adjustment is
stopped by pressing the
MENU key during the auto
adjustment operation.
SIZE H Adjusts the horizontal size of the
picture. The higher the setting, the
larger the width of the picture.
The lower the setting, the narrower
the width of the picture.
SIZE V Adjusts the vertical size of the
picture. The higher the setting, the
larger the height of the picture. The
lower the setting, the smaller the
height of the picture.
SHIFT H Adjusts the position of the picture.
As the setting increases, the picture
moves to the right, and as the
setting decreases, the picture moves
to the left.
SHIFT V As the setting increases, the picture
moves up, and as the setting
decreases, the picture moves down.
DOT PHASE Adjusts the dot phase. Adjust the
picture further for a finer picture
after the picture is adjusted by
pressing the APA key.
Submenu Setting
PITCH Adjusts the horizontal size of the
picture with the left side of the
picture fixed. The higher the
setting, the larger the width of the
picture. The lower the setting, the
narrower the width of the picture.
RESET Resets the value of SIZE H, SIZE
V, SHIFT H, SHIFT V, DOT
PHASE and PITCH to the factory
preset value.
Submenu Setting
PARALLEL
REMOTE
Select the REMOTE connector pins for
which you want to change the function.
You can assign various functions to 1 to
4 pins and 6 to 8 pins. The following
lists the functions you can assign to the
pins.
• – – – (“– – –”: No function is
assigned.)
• COMPOSITE
•Y/C
•RGB
• COMPONENT
•DVI
• HD15
• OPTION A-1
• OPTION A-2
• OPTION B-1
• OPTION B-2
• UNDERSCAN
• OVERSCAN
•FULL
•ZOOM
•NATIVE
•4:3
•16:9
•TALLY
• EXT SYNC (External Sync)
Notes
• If you use the parallel remote
function, you need to connect
cables. For more details, see
page 27.
• When “OFF” is selected in the
INPUT SELECT menu and the
function is assigned, the remote
function does not work. Select
“ON” to use the parallel remote
function (on page 24).
Submenu Setting
xPARALLEL REMOTE...
· SERIAL REMOTE xxxxxxx
REMOTE
