80
The recorder does
not work or works
poorly.
• The recorder is operated when it is on a battery charging stand.
, Remove the recorder from the battery charging stand.
• You tried to turn group mode on while setting the program.
, Turn group mode on before setting the program.
• There is an internal malfunction in the system.
, Remove the recorder from the USB cradle, restart your
computer, and then place the recorder on the USB cradle again.
The recorder does
not work while
connected to the
computer.
• The computer does not recognize the recorder.
, Verify that the recorder is correctly connected.
, Place the recorder correctly on the USB cradle.
, Install the driver correctly into your computer.
, Install the OpenMG software into your computer first, and then
connect the recorder.
The recorder
overwrites
existing materials
when record.
• The record starting-position setting (“REC-Posi”) is set to “From
Here”.
, Set “REC-Posi” setting to “From End”.
“NO SIGNAL”
appears in the
display when
recording from a
portable CD
player.
• There is no digital signal from the portable CD player.
, When recording digitally from a portable CD player, use the AC
power adaptor and disable the anti-skip function (such as ESP)
on the CD player (page 22).
There is no
recording on the
MD after a
recording
operation.
• The AC power adaptor was unplugged or a power outage occurred
during recording.
The lid does not
open.
• The power sources have been disconnected during recording or
editing, or the battery have been exhausted.
, Set the power sources again, or replace the exhausted battery
with new ones.
• Check-in/Check-out is not finished.
, After the dialog box in the display window of your computer
disappears and the display window of the recorder indicates that
the recorder has stopped, flip the control bar towards x on the
recorder and remove the recorder from the USB cradle.
Symptom Cause/Solution
