37
System Setup
4
Press the select R button when you are finished
making adjustments.
The adjusted values are stored.
To cancel an adjusted value, press the select L button.
• LCD Brightness
Adjust the brightness of the display window in seven steps.
The default setting is “3”. You can adjust the brightness
referring to the Sample shown at the bottom of the screen.
• F-KEY LED Brightness
Adjust the brightness of the function buttons in seven
steps. The default setting is “5” (brightest). You can adjust
the brightness referring to the Sample shown at the bottom
of the screen.
• Sound Control
Adjust the sound level of the touch-panel beep. The default
setting is “3.” When the sound level is changed, Sound
Test is executed.
• Sound Test
Displays “Now testing of sound” while the sound level is
adjusted with Sound Control.
• TouchEngine Force: ON/HIGH
Adjust the sensitivity of the TouchEngine in four levels,
OFF, ON/LOW, ON/MIDDLE, and ON/HIGH.
• Touch Beep Control
Enable/disable the touch-panel beep.
Adjust Time
Set the date and time. The set date and time are retained in
memory for about 7 days even if the power is turned off.
1
Press the jog L or R button to select the digit to be
adjusted.
2
Turn the jog roller to set the value.
3
Press the select R button when setting is completed.
The adjusted values are stored.
To cancel the adjustment, press the select L button.
Set TCP/IP Config.
The IP Address, Netmask, Gateway, and DNS have been
set at the factory, but you can change them as required.
1
Press the jog roller to select an item to be changed.
2
Press the jog L or R button to select the digit to be
changed.
3
Turn the jog roller to set the value.
4
Press the select R button when you are finished
settings.
The set values are stored.
5
Press the select R button to reflect the settings.
The system is rebooted.
To cancel the set values, press the select L button.
To retrieve the default settings, select Default.
Calibrating the Touch Panel
Push the center of the crosshairs displayed in the four
corners on the touch panel in order with a pen or fingertip.
The relationship between the screen and touched position
is calibrated.
To calibrate from the beginning again, push some place
apart from the crosshairs on the touch panel until the
crosshairs appear in the upper-left corner. Then the
previous operation is canceled, and you can start the
calibration from the beginning.
Scribble Test
You can check the operation status of the touch panel by
scribbling. Scribble on the screen with a pen, and the trace
will be shown.
Self Diagnosis
The operation of the jog roller, jog buttons, function
buttons, and control knobs can be checked.
