Chapter 2 Managing RAS Features and System Firmware 25
■ “Unconfiguring and Reconfiguring Devices” on page 27
■ “To Reconfigure a Device Manually” on page 27
■ “Obtaining Automatic System Recovery Information” on page 26
Enabling and Disabling Automatic System
Recovery
The ASR feature is not activated until you enable it. Enabling ASR requires changing
configuration variables in ALOM as well as OpenBoot firmware.
▼ To Enable Automatic System Recovery
1. At the sc> prompt, type:
2. At the ok prompt, type:
3. To cause the parameter changes to take effect, type:
The system permanently stores the parameter changes and boots automatically
when the OpenBoot configuration variable auto-boot? is set to true (its default
value).
Note – To store parameter changes, you can also power cycle the system using the
front panel Power button.
sc> setsc diag_mode normal
sc> setsc diag_level min
sc> setsc diag_trigger power-on-reset
ok setenv auto-boot? true
ok setenv auto-boot-on-error? true
ok reset-all
