Tripp Lite SMART1000RM2U Manual

next previous

Basic Operation continued

Control Menu Options

Enable/Disable Alarm

Tap the buttonrepeatedlytoadvancetotheLCDdisplayfeaturingthe icon. Press the

buttontoselectONorOFFalarmmodesettings.Thelastoptiondisplayedbeforenavigatingaway

from this menu option will be the selected setting.

Note: Disabling the alarm via this control menu option will silence the alarm under all conditions, including low

battery conditions.

LCD Brightness

Tap the buttonrepeatedlytoadvancetotheLCDBrightnessdisplaymarked“LCD.”Pressthe

button to select Medium Backlight (default), High Backlight or Dim Backlight. The last option

displayed before navigating away from this menu option will be the selected setting.

Note: The default brightness is set at medium. Any time a button is pressed, the LCD will engage the high brightness

setting. After 2 minutes of inactivity, the backlight will revert to the selected setting until a button is pressed.

Self-test

Tap the buttonrepeatedlytoadvancetotheTESTBATTdisplay.Pressthe button to initiate

thetest.Thetestwilllastapproximately 10secondsastheUPSswitchestobatterytotestthe

capacitywithaload.Uponcompletionofthetest,thedisplaywillindicatePASorBAD(passorbad)

for20seconds,andthenreturntothehomescreen.Connectedequipmentcanremainonduring

thetest.DonotunplugyourUPStotestit;thiswillremovesafeelectricalgrounding.

Note: If the self-test result is BAD, it may be due to the batteries not being charged for 24 hours. Fully charge the

batteries and repeat the self-test. Please refer to the note under Step 3 on Page 6.

Scroll Control

This settingisnormally setto “OFF.” Settingit to“ON” allowstheuser toselect theoption to

automaticallyscrolleachoperatingconditionoftheUPS(suchasInputVoltage,OutputVoltageand

Runtime) automatically.

Tap the button repeatedly to advance to the Scroll display as shown above.

Press the  buttontoadvance tothe nextavailable option.The lastoptiondisplayed, before

navigating away from this menu option, will be the selected setting.

Note:

1. Each condition is displayed in 2-second intervals.

2. If a button is pressed while Scroll Mode is enabled, the scroll function will pause for 10 seconds to allow the

user to manually make menu selections.

201205048 93-3149.indb 13 6/19/2012 11:33:40 AM