A SERVICE OF

logo

Open as PDF
next previous
Mounting (Tower)
MounttheUPSsysteminanupright,towerpositionusing2-9USTANDbasestands(optional).Theusermustdeterminethefitnessofhardware
andproceduresbeforemounting.
WARNING! The UPS system is extremely heavy. Use caution when lifting and mounting. User must properly stabilize the UPS when
lifting and mounting.
Adjust the stands to a width of 6.93
inches(176mm)foraUPS.Adjustthe
standstoawidthof12.07inches(306.5
mm)foraUPSandanexternalbattery
module.Alignthestandsapproximately
10inches(254mm)apart.Haveoneor
moreassistantshelpyouplacetheUPS
onitssideinthestands.PlacetheUPS
sothat itscontrol panelis ontop and
facingoutward.
RotatetheUPS'scontrolpaneltoview
iteasierwhiletheUPSistowermounted.
Insertasmallscrewdriver,orothertool,
intheslotsoneithersideofthecontrol
panel.Popthepanelout;rotateit;and
popthepanelbackintoplace.
5
Mounting
3
2
1
4
1
2
1 Power Module
6.93" (176 mm)
1 Power Module +
1 Battery Module
12.07" (306.5 mm)
1 Power Module
6.93" (176 mm)
1 Power Module +
1 Battery Module
12.07" (306.5 mm)
1
1
I/P BYPASS
BATTERY AC/DC DC/AC
O/P
OFF
ON
MUTE
SELECT
SETUP
2
Mounting (4-Post Rackmount)
TheUPSincludesrackmountrailsfor4-postrackmounting.Theusermustdeterminethefitnessofhardwareandproceduresbeforemounting.
Ifhardwareandproceduresarenotsuitableforyourapplication,contactthemanufacturerofyourrackorrackenclosure.Theprocedures
describedinthismanualareforcommonrackandrackenclosuretypesandmaynotbeappropriateforallapplications.
WARNING! The UPS system is extremely heavy. Use caution when lifting and mounting. User must properly stabilize the UPS when
lifting and mounting.
Connectthetwosegmentsofeachshelf
usingtheincludedattachedscrewsand
wing nuts. Leave the screws slightly
loosesothattheshelvescanbeadjusted
inthenextstep.
Adjusteachshelftofityourrack,then
mount them in the lowest available
spaceofyourrackwiththescrews,nuts
and washers provided. Note that the
support ledges should face inward.
Tighten the wingnuts that connect the
shelf segments.
Attach mounting ears to the front
mountingholesofyourUPSusingthe
screwsprovided. The earsshould face
forward.
Usingoneor moreassistants,liftyour
UPS and slide it onto the mounting
shelves.AttachyourUPStotherackby
passingscrews,nutsandwashers(user-
provided)throughitsmountingearsand
intotherackrails.
Mounting (2-Post Rackmount)
If you mount this UPS model in 2-post racks, it requires the addition of a Tripp Lite 2-Post Rackmount Installation Kit (model:
2POSTRMKITWM,soldseparately).SeeInstallationKitowner'smanualforinstallationprocedure.
1
2
3
4
201102170 932611.indd 5 3/30/2011 10:22:11 AM