60133 revG Page 17 of 38
Installing Turbo Oiling System
Turbo Oil Feed
1. Locate the oil sending unit on the driver’s side of the head. On top of the radiator hose connection. SEE
FIGURE 37
FIGURE 37
2. Unplug the wires that are connected to the sensor and using a 24mm socket, remove the sensor from the
head.
3. Re-tap the threaded hole using the supplied 1/8-27 NPT tap. Make sure you coat the tap with a lot of
grease so no chips from the re-thread will enter the motor.
4. Apply a small amount of thread sealant to the threads of the sensor and install the factory oil sensor to
the supplied brass T fitting as shown in the picture below. It is recommended that you use a liquid thread
sealant. When using a tape style thread sealant, make sure the tape does not get into the oil passages.
5. Hand thread the brass T fitting to the head and use a 24mm socket to tighten.
6. Once the T fitting is tighten, make sure the threaded port of the fitting is facing toward you with a slight
angle upwards. SEE FIGURE 38
7. Install and tighten the supplied brass 1/8 NPT to -3AN fitting to the threaded port on the T- fitting. Apply a
small amount of thread sealant to the threads of the fitting. SEE FIGURE 38
FIGURE 38
