12
E
N
G
L
I
S
H
Optiquest Z90
Other Information
Troubleshooting
No power
• Make sure power button (or switch) is ON.
• Make sure A/C power cord is securely connected to the back of the monitor and
to a power outlet.
• Plug another electrical device (like a radio) into the power outlet to verify that the
outlet is supplying proper voltage.
Power on but no screen image
• Make sure the video cable supplied with the monitor is tightly secured to the video
output port on the back of the computer. If the other end of the video cable is not
attached permanently to the monitor, tightly secure it to the monitor.
• Adjust brightness and contrast.
• Check this user's guide to see if an adapter is required for proper signal continuity
between graphics card and monitor.
Faint horizontal linesFaint horizontal lines
Faint horizontal linesFaint horizontal lines
Faint horizontal lines
• Caused by steel wires called Damper Wires. This is normal for all monitors that
employ aperture grille technology, the source of superior, rich color.
Flickering
• Not enough power supplied. Connect the monitor to a different outlet. If using a
surge protector, reduce the number of devices plugged in.
• Check the ViewMeter
®
from the main menu to verify the refresh rate (vertical
frequency) is 75 Hz or higher. See Specifications.
• Make sure the graphics card in your computer can use non-interlaced mode at the
desired frequencies. To enable your graphics card to support higher refresh rates,
try selecting fewer colors or running lower resolutions.
• Remove any devices from the area around the monitor that emits magnetic fields
such as radios, surge protectors, unshielded speakers, fluorescent lights, AC
power converters, desk fans, etc.
Wrong or abnormal colors
• If any colors (red, green, or blue) are missing, check the video cable to make sure
it is securely connected. Loose or broken pins in the cable connector could cause
an improper connection.
• Connect the monitor to another computer.
• Select Degauss from the Main Menu.
• If you have an older graphics card, contact ViewSonic
®
for a non-DDC adapter.
Entire screen image scrolls (rolls) vertically
• Make sure video input signals are within the monitor's specified frequency range.
• Try the monitor with another power source, graphics card, or computer system.
• Connect the video cable securely.
Control buttons do not work
• Press only one button at a time.
