A SERVICE OF

logo

8-6 Maintenance
Automatic Document Feeder Rubber Pad
Replacement
1
Open the Control Panel Cover.
2 Insert a small flat blade screwdriver under the right and left sides of the
ADF Holder.
3 Apply upward pressure to release the two locking tabs on each side of
the assembly.
4 Remove the assembly and replace the ADF Rubber.
5 Reassemble the components in the order shown in the diagram above.
6 Place the assembly back onto the ADF Holder.
7 Press down on the assembly until it locks into position.
8 Close the Control Panel.
ADF Holder
ADF Sheet
ADF Rubber