Advanced Techniques
Setting Parameters using Menu Mode
62
DTX502 Owner’s Manual
KitC3 Reverb Type
q RevType
Use this parameter to select the type of reverb to be applied.
KitC4
Reverb Return
q RevMastRet
Use this parameter to set the reverb unit’s return level.
KitC5
Pad Control
q PadCtl
When a pad unit equipped with a pad controller is connected
to the [qSNARE] jack, this parameter can be used to select a
function for the controller.
KitC6
Snare Adjustment
q Snares
Use this parameter to adjust the snare-wire tension for the pad
connected to the [qSNARE] jack. An “off” setting simulates
the snare wires being fully removed from the head.
KitC7
Tempo
q Tempo
Use this parameter to specify the tempo to be set automati-
cally upon selection of the current drum kit. When set to
“off”, the tempo will not change automatically when the cur-
rent kit is selected.
Settings
none, hall1, hall2, hall3, room1, room2,
room3, stage1, stage2, plate
Settings
0 to 127
NOTE
The reverb return level can be adjusted to balance the volumes
of the sounds with reverb applied and those without.
Settings Description
off Pad controller performs no function.
snares
Adjustment of snare-wire tension (also affect-
ing open-rim sounds)
tuning
Adjustment of tuning (also affecting open-rim
sounds)
tempo Adjustment of the tempo
Settings Description
off Snare wires fully removed
1 to 24
Higher values correspond to tighter snare
wires and vice-versa.
Settings
off, 30 to 300
>Ki
t
C5
”PacC
t
l=snares ‚
q
>Ki
t
C6
” Snares= 4 ‚
q
