GB-12
EXZ2610DL
(1)
(1)
(2)
(3)
6. Set up (BC-EX only)
INSTALLING CUTTING ATTACHMENT GUARD
• Put the cutting attachment guard on the gearbox, at-
tach it with the 4 screws and hardware provided.
(1) Cutting attachment guard
(2) Plate
(3) Screw
INSTALLING CUTTING HEAD
1. While locking the gear shaft, by inserting the supplied
tool into the upper holder on the gearbox, loosen and
remove the hexagon nut (left-handed).
2. Then screw in the cutting head to the gear shaft over
the holders. Hand-tighten it securely.
HARNESS
(1)
WARNING
ALWAYS WEAR THE PROVIDED HARNESS WHEN
USING THE MACHINE!
Always make sure the machine is hooked securely
to the harness.
If you don't, you will be unable to control the machine
safely. This can result in injury to yourself or others.
Never use a harness with a defective quick release
or any other damage.
HOW TO WEAR
1. Wear the provided harness without twisted bands, with
the hanger on your right side.
(1) Hanger
BALANCE THE UNIT
1. Hook your machine to the hanger.
2. Adjust the bands of the harness to have the blade
parallel to the ground when standing in your normal
working position to provide you most effectiveness
and comfort on operating the machine.
3. In order to prevent the hanger position to change
during operation, turn up the extra part of the band
from the buckle.
QUICK RELEASE
The harness is equipped with a "QUICK RELEASE"devise.
To release the machine from the harness in emergency
situations, please follow the procedure as explained
below.
WARNING
Make sure to check proper working of the QUICK RE-
LEASE device BEFORE operating the machine.
Make sure to hold the unit securely when using the
QUICK RELEASE.
While holding the unit by your right hand securely, press
both sides of the
buckle. sides of the buckle.
(1) Buckle
4. When correctly adjusted, check the correct working
of the harnesses' QUICK RELEASE.
