GB-24
EXZ2610DL
WARNING
• Always wear eye protection such as safety
goggles. Never lean over the rotating cutting head.
Rocks or other debris could be thrown into eyes
and face and cause serious personal injury.
• Keep the blade guard and the mad guard attached
in place at all times when the unit is operated.
• Before starting a job, check the area and remove
all obstacles and objects that could be thrown by
the blade.
• Do not adjust the wheel height or try to remove
anything entangled to the blade with the engine
running.
1. Before starting the engine, adjust the wheel height
for desired cutting depth (see page 15).
2. Before starting a job, plan your direction of travel so
that you can always hold the edger on you right side
and can walk on a hard surface as much as possible.
3. When starting to edge, run the engine at full throttle,
and slowly have the blade cut into the edge groove.
NOTE
• Do not use the HE-EX to make a new groove into the
ground. Such usage will not be covered by ZENOAH
Warranty.
8. Operation (HE-EX only)
BLADE
ROTATION
8. Operation (PS-EX only)
Adjust the pump as follows:
1. Stop the engine and make sure the stop switch is in
the OFF position.
2. Place the unit on its side with the oil reservoir up.
(1) Oil tank (2) Chain cover
IMPORTANT
The oil flow adjusting screw must be pressed in slightly
in order to turn. Failure to do so could damage the
pump and screw.
3. With a screwdriver, push in on the oil flow rate adjust-
ing screw and turn in the desired direction (there are
three incremental settings):
(a) Clockwise-decrease lubrication
(b) Counter clockwise-increase lubrication
(c) Middle
WARNING
• Always wear work gloves made of leather or some
other sturdy material when using the polesaw.
• Falling branches may fall onto the face or into the
eyes, resulting in injuries, scratches, and cuts, and
for this reason you should always be sure to wear
a helmet and face protector when using your
polesaw.
