A SERVICE OF

logo

Chapter 2 Hardware Installation and Connections
IES-5106M / IES-5112M / IES-6000M User’s Guide
32
Figure 25 Tightening Splitter Chassis Card Thumbscrews
2.3.4 Removing a Splitter Chassis Card
Use the following procedure to remove a splitter or extension card from the
splitter chassis.
1 Disconnect the cable from the card.
2 Loosen the two thumbscrews.
3 Grasp the handles on the front panel of the card and start to pull the card out.
4 After you have the card partially out of the splitter chassis, place one hand under
the card to support it.
5 Slide the card out of the slot.