Chapter 33 Maintenance
MGS-3712/MGS-3712F User’s Guide
298
33.2 Load Factory Default
Follow the steps below to reset the Switch back to the factory defaults.
1 In the Maintenance screen, click the Click Here button next to Load Factory
Default to clear all Switch configuration information you configured and return to
the factory defaults.
2 Click OK to reset all Switch configurations to the factory defaults.
Figure 164 Load Factory Default: Start
3 In the web configurator, click the Save button in the top of the screen to make the
changes take effect. If you want to access the Switch web configurator again, you
may need to change the IP address of your computer to be in the same subnet as
that of the default Switch IP address (192.168.1.1).
33.3 Save Configuration
Click Config 1 to save the current configuration settings permanently to
Configuration 1 on the Switch.
Load
Factory
Default
Click Click Here to reset the configuration to the factory default settings.
Save
Configuratio
n
Click Config 1 to save the current configuration settings to Configuration
1 on the Switch.
Click Config 2 to save the current configuration settings to Configuration
2 on the Switch.
Reboot
System
Click Config 1 to reboot the system and load Configuration 1 on the
Switch.
Click Config 2 to reboot the system and load Configuration 2 on the
Switch.
Note: Make sure to click the Save button in any screen to save your
settings to the current configuration on the Switch.
Table 99 Management > Maintenance (continued)
LABEL DESCRIPTION
