set ipv4_method=dhcp
#set ipv4_method=static #ipv4_address=192.168.160.10 #ipv4_
mask=255.255.255.0
#set ipv4_method=ipv4_address_unconfigured
#set ipv6_method=stateless
#set ipv6_method=dhcpv6
#set ipv6_method=static #ipv6_address= #ipv6_prefix_length=
set ipv6_method=ipv6_address_unconfigured
set mode=auto
submit
echo on
commit
--:- eth0 cli->
NOTE: Checkthe configuration of the program used to open asession againstthe appliance (SSH/Telnet,
TeraTerm / HypertTerminalfor console, and so on) to avoidthe inclusion of aline feed character in linesthat exceed
terminalwidth, becausethiswillaffect the past operation.
cycle, on, off, lock and unlock
Control power on outlets on a PDU that is either connected to a serial port or to the
AUX/Modem port when the port is enabled and configured with the Power Profile.
NOTE: Lockand unlockcommandsare onlysupported on Cycladesand Avocent PDUs.
To power control (on, off, cycle) all outlets of PDUs or outlets merged to a target
(serial port configured as CAS profile with merged outlets):
1. Go to the access level.
--:- / cli-> cd/access
2. Launch the power command with the argument being the target name or PDU ID.
--:- access cli-> [cycle|on|off][<PDU_ID>]|<target name>]
To power control (on, off, cycle) outlets of one specific PDU:
1. Go to the PDU level under access.
--:- / cli-> cd access/<PDU_ID>
2. Launch the power command with a specific outlet (number or name), range of outlets (use a
hyphen to specify the range) or list of outlets (number or name separated by a comma).
--:-
<PDU_ID>
cli->
[cycle|on|off][<outlet name>|<outlet number>]-or-
--:-
<PDU_ID>
cli->
[cycle|on|off]<outlet number>-<outlet number]-or-
Chapter 2: CLI Command Set 15
