wiz
Configures the IP parameters for the Eth0 interface. Shows the current configuration and asks
for new values for the following parameters:
• Status of the interface (enabled or disabled)
• IPv4 method (dhcp or static)
• IPv6 method (dhcp or static)
• IP address, mask and gateway (if static is chosen for either of the previous parameters)
• DNS Primary Server, Secondary Server, Domain Name and Hostname
After setting all parameters, confirm that all parameters are correct to save them.
Special Multi-session Commands
The following commands require navigation to an enabled and configured port to which one or
more users are simultaneously connected. To get to the port, enter the following command.
--:- / cli-> cd access/<serial_port_ID>
list_shared_session
List the users connected to the shared serial port.
Syntax:
--:- <serial_port_ID> cli-> list_shared_session
kill_shared_session
Terminate the connection of a user on the port. The user is returned to the cli-> prompt.
Syntax:
--:- <serial_port_ID> cli-> kill_shared_session <username>
Example:
--:- <serial_port_ID> cli-> kill_shared_session admin@139
sendmsg
Send a message to a user connected to the port.
Syntax:
--:- <serial_port_ID> cli-> sendmsg <username> <message>
Example:
Chapter 2: CLI Command Set 17
