Billion BiPAC 8500/8501/8520/8521 SHDSL (VPN) Firewall Bridge/ Router
Chapter 3: Basic Installation
23
Factory Default Settings
Before configuring your router, you need to know the following default settings.
Web Interface (Username and Password):
Username: admin
Password: admin
The default username and password are “admin” and “admin” respectively.
Device LAN IP Settings:
IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0
ISP setting in WAN site:
PPPoE
DHCP server:
DHCP server is enabled.
Start IP Address: 192.168.1.100
IP pool counts: 100
LAN and WAN Port Addresses
The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown
below.
LAN Port WAN Port
IP address 192.168.1.254
Subnet Mask 255.255.255.0
DHCP server function Enabled
IP addresses for
distribution to PCs
100 IP addresses ranging from
192.168.1.100 to 192.168.1.199
The PPPoE function is
enabled to automatically get
the WAN port configuration
from the ISP.
Attention
If you ever forget the username/password to login to the router, you may
press the RESET button up to 6 seconds to restore the factory default
settings.
Caution: After pressing the RESET button for more than 6 seconds, to be
Attention
