
117
Before Use
Basic Guide
Advanced Guide
1
Camera Basics
2
Auto Mode /
Hybrid Auto Mode
3
Other Shooting Modes
5
Tv, Av, M, C1, and C2 Mode
6
Playback Mode
7
Wi-Fi Functions
8
Setting Menu
9
Accessories
10
Appendix
Index
4
P Mode
3
Adjust the cropping area.
● A frame is displayed around the portion of
the image to be cropped (1).
● The original image is shown in the upper
left, and a preview of the image as
cropped (2) is shown in the lower right.
You can also see the resolution after
cropping (3).
● To resize the frame, move the zoom
lever.
● To move the frame, press the
[
][ ][ ][ ] buttons.
● To change the frame orientation, press
the [
] button.
● Faces detected in the image are
enclosed in gray frames in the upper-left
image.
To crop the image based on this frame,
turn the [
] dial to switch to the other
frame.
● Press the [
] button.
4
Save as a new image and review.
● Follow steps 4 – 5 in “Resizing Images”
(
=
116).
● Editing is not possible for images shot at a resolution of [ ]
(
=
52) or resized to [ ] (
=
116).
● RAW images cannot be edited.
● Images supported for cropping will have the same aspect ratio
after cropping.
● Cropped images will have a lower resolution than uncropped
images.
● If you crop still images shot using Face ID (
=
47), only the
names of the people left in the cropped image will remain.
5
Review the new image.
● Press the [ ] button. [Display new
image?] is displayed.
● Press the [
][ ] buttons to choose [Yes],
and then press the [ ] button.
● The saved image is now displayed.
● Editing is not possible for images shot at a resolution of [ ]
(
=
52).
● RAW images cannot be edited.
● Images cannot be resized to a higher resolution.
Cropping
Still Images
Movies
You can specify a portion of an image to save as a separate image le.
1
Choose [Cropping].
● Press the [ ] button, and then
choose [Cropping] on the [ ] tab
(
=
30).
2
Choose an image.
● Press the [ ][ ] buttons to choose an
image, and then press the [ ] button.