xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
BGP Neighbor Map & Filter Settings
This window is used to configure BGP neighbor map and filter settings.
To view this window, click L3 Features > BGP > BGP Neighbor Map & FilterSettings, as shown below:
Figure 4- 140. BGP Neighbor Map & Filter Settings window
To configure BGP neighbor map & filter settings on the Switch, complete the following fields:
Parameter Description
BGP Neighbor Map Settings
IP Address
Enter the IP address of the neighbor to be configured.
Peer Group Name
Enter the peer group to be configured.
Unsuppress Map
Action
Toggle between Add and Delete.
Unsuppress Map
Name
Enter the name of a route map used to selectively advertise routes previously suppressed by
the aggregate address command.
Route Map Type
Toggle between In and Out. In specifies the incoming routes from the neighbor and Out
specifies the outgoing routes sent to the peer.
Route Map Action
Toggle between Add and Delete.
Route Map Name
Enter the route map to be applied to the incoming or outgoing routes.
BGP Neighbor Filter Settings
282
