3 - 6 Document #98210104
(A) - 25 Pin Cable (20’) - Connect the 25 Pin
Cable to the Hardware Stack.
(B) - Data Acquisition Cable (40’) - Connect
the Data Acquisition Cable to the Pick
Up Card on the 248 dyno. (Run into 248
pit)
(C) - Multi-Purpose Wire
- Brake Power Cord (40’) - Connect to
the spade connector on the new 248
air assembly.
- Prop Air Cable (40’) - optional for
load control system, attaches to the EPR.
- Temp Sensor Cable - optional, part of
the Prop Air load control system.
(D) - 224-4WD Power Cord (20’) - Plug the
224-4WD Power Cord into the Power
Supply.
(E) - Control Pendant (20’) - Connect to the
Control Pendant. The Control Pendant
moves the 224-4WD dyno.
(F) - Air Hose (20’) - Connect the Air Hose to
a 100 120 psi air supply with clean dry
air.
Step 2
Plug the two pin connector from the Model 224-
4WD dyno (pg 3-22, letter C) into the (2) black
wires on the air assembly of the 248 dyno.
Step 3 (Prop - Air Only)
Install the Temperature Sensor on the left 4”X4”
post.
Locate the temperature sensor bracket on the
left side 4”X”4 post.
