A SERVICE OF

logo

Page 82
IEI
®
Technology, Corp.
KINO-LX Motherboard
4.6 Jumper Settings
NOTE:
A jumper is a metal bridge that is used to
close an electrical circuit. It consists of
two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper
means removing the plastic clip from a
jumper.
Jumper
Description Label Type
Clear CMOS JP4 3-pin header
LCD voltage select JP3 3-pin header
COM2 RS-232/422/485 select JP2 6-pin header
COM1/2 RI and voltage select JP1 10-pin header
LCD clock setup JP5 3-pin header
AT/ATX power mode select JP6 2-pin header
Table 4-2: Jumpers