8
The Aqua Logic’s five main menus have many items in each that allow you to customize the operation of
your pool/spa equipment. The chart on the previous page shows the Aqua Logic’s five menus as well as
each menu’s specific settings.
The Default Menu is a series of informative displays (temperatures, salt levels, chlorinator settings, etc.)
with nothing to set. The Aqua Logic will automatically switch to the default menu when no keys have been
pressed for 2 minutes and will then scroll through each display.
The Settings Menu and the Timers Menu are the menus you will be using most often to adjust the operation
of your pool. The Configuration Menu is used when the system is installed and defines what equipment is
connected to each output and the operational logic that will control the equipment. This menu is normally
“locked” and should only be used by a pool professional. Details regarding the Configuration menu can be
found on page 16.
The “Diagnostic Menu” is primarily intended for the service technician and contains information and details
about the system operation that are helpful in troubleshooting, if problems occur.
Settings Menu
The Settings Menu allows you to set all system operating parameters except the timeclock and countdown
timers which are part of the Timers Menu.
Important: All of the displays shown below use the default generic names for each function
or output. The Aqua Logic allows more descriptive names to be assigned to each piece of equip-
ment (refer to the section regarding the Configuration Menu for more information).
Spa Heater2
102°F
Spa Heater1
Off
Adjust the desired spa temperature (Off, 65°F, 66°F, ...103°F, 104°F, Off)
Adjust the desired spa temperature (Off, 65°F, 66°F, ...103°F, 104°F, Off)
Move to previous/next menu item
Move to previous/next menu item
+
+
>
>
>
>
not shown if Pool
and Spa-Dual is selected
The spa heater setting will only appear if the system has been setup for “spa only” or “pool
and spa” operation and the “Heater1” and/or “Heater2” control is enabled. The heater will
turn on whenever the pool/spa valves are in the “spa only” position and the filter pump is
running and the spa water temperature is less than the desired temperature setting. If you
have both solar heat and a conventional heater and the solar priority option is selected
(Configuration Menu), then the conventional heater will only operate when solar heat is
NOT available.
For Pool and Spa dual equipment with separate heaters (“Pool and Spa -Dual” and “Htr1=Spa,
Htr2=Pool” selected), Spa Heater1 is tied to the Spa Filter (AUX1).
Pool Heater2
85°F
Pool Heater1
Off
Adjust the desired pool temperature (Off, 65°F, 66°F, ...103°F, 104°F, Off)
Adjust the desired pool temperature (Off, 65°F, 66°F, ...103°F, 104°F, Off)
Move to previous/next menu item
Move to previous/next menu item
+
+
>
>
not shown if Pool
The pool heater setting will only appear if the system has been setup for “pool only” or “pool
and spa” operation and the “Heater1” and/or “Heater2” control is enabled. The heater will
35
ons and (Liters) of Pool/Spa water
18,000 20,000 22,000 32,00024,000 34,00026,000 36,00028,000 38,00030,000 40,000
Current salt
level
(45000) (52,500) (60,000)
(67,500) (75,000) (82,500) (120,000)(90,000) (127,500)(97,500) (135,000)(105,000) (142,500)(112,500) (150,000)
ppm
0
320
(145)
373
(170)
427
(194)
480
(218)
(242)
587 854
(267) (388)
640 907
(291) (412)
693 960
(315) (436)
747
(339) (4
60)
1067
(484)
200
300
(136)
350
(159)
400
(182)
450
(205)
500
(227)
550 800
(250)
(363)
600 850
(273) (385)
650 900
(295) (408)
700 9
50
0)
1000
(453)
400
280
(127)
327
(148)
373
(170)
420
(191)
467
(212)
513 747
(233) (339)
560 793
(255) (360)
607 840
(276) (382)
653 88
7
03)
933
(424)
600
260
(118)
303
(138)
347
(158)
390
(177)
433
(197)
477 693
(217) (317)
520 737
(236) (337)
563 780
(256) (358)
607 8
23
78)
867
(398)
800
240
(109)
280
(127)
320
(145)
360
(164)
400
(182)
440 640
(200) (291)
480 680
(218)
(310)
520 720
(236) (328)
560 76
0
46)
800
(364)
1000
220
(100)
257
(117)
293
(133)
330
(150)
367
(167)
403 587
(183) (267)
440 623
(200) (283)
477 660
(217) (300)
513 69
7
17)
733
(333)
1200
200
(91)
233
(106)
267
(121)
300
(136)
333
(152)
367 533
(167) (243)
400 567
(182) (258)
433 600
(197) (274)
467 63
3
89)
667
(304)
1400
180
(82)
210
(95)
240
(109)
270
(123)
300
(136)
330 480
(150) (218)
360 510
(164) (232)
390 540
(177) (246)
420 57
0
59)
600
(263)
1600
160
(73)
187
(85)
213
(97)
240
(109)
267
(121)
293 427
(133)
(195)
320 453
(145) (207)
347 480
(158) (219)
373 50
7
31)
533
(243)
1800
140
(64)
163
(74)
187
(85)
210
(95)
233
(106)
257 373
(117) (169)
280 397
(127) (180)
303 420
(138) (190)
327 44
3
1)
467
(211)
2000
120
100
80
60
20
40
(55)
(45)
(36)
(27)
(9)
(18)
140
117
23
47
(64)
(53)
(11)
(21)
160
133
27
53
(73)
(61)
(12)
(24)
180
150
30
60
(82)
(68)
(14)
(27)
200
167
33
67
(91)
(76)
(15)
(30)
220 320
183 267
37 53
73 107
(100) (145)
(83) (121)
(17) (24)
(33) (48)
240
340
200 283
40
57
80 113
(109) (154)
(91) (129)
(18) (26)
(36) (51)
260 360
217 300
43 60
87 120
(118) (163)
(98) (137)
(20) (27)
(39) (54)
280 38
0
7
3
27
2)
4)
9)
7)
400
333
67
133
(181)
(152)
(30)
(60)
(32)
80
(36)
90
(41)
100
(45)
110 160
(50) (73)
120 170
(55) (77)
130 180
(59) (81)
140
190
(64) (86)
150 200
(68) (90)
93
(42)
107
(48)
120
(55)
133
(61)
147 213
(67) (98)
160
227
(73) (104)
173 240
(79) (110)
187 253
(85) (117)
200
267
(91) (123)
2200
3000
2800
2400
3200
Ideal Ideal Ideal Ideal Ideal
Ideal IdealIdeal IdealIdeal IdealIdeal IdealIdeal Ideal
OK OKOK OKOK OKOK OKOK OK
POUNDS and (Kg) OF SALT NEEDED FOR 3200 PPM
te Dilute Dilute Dilute DiluteDilute DiluteDilute DiluteDilute DiluteDilute Dilute
10,000
8,000
(37,500)
213
267
(97)
(121)
200 250
(91) (114)
187 233
(85)
(106)
173
217
(79)
(98)
160 200
(73)
(91)
147 183
(67) (83)
133 167
(61) (76)
120 150
(55) (68)
107 133
(48) (61)
93 117
(42) (53)
80 100
67 83
53
67
40 50
13 17
27 33
(36) (45)
(30) (38)
(24) (30)
(18) (23)
(6) (8)
(12)
(15)
Ideal
Ideal
Dilute
Dilute
(30,000)
