Command Line Interface
remote upgradereboot <ip-address> <url> <key>
Upgrades the system at the specified IP address and reboots the system.
<url> The URL encoded location of the software release to install. The format of the URL is
<protocol>://<host>/<update file> or
<protocol>
://<username>
[:<password>
]@<host>/<update file>
<protocol> can be ftp, http, or tftp.
<username>[:<password>] specifies a username and optional password with
access to the remote site, if required.
<update file> is the filename (including the path) of the software image.
For TFTP or anonymous FTP, the path is relative to the FTP or TFTP root. If a
username and password is required for FTP, then the full path to the update file must
be specified. For HTTP, the path is always relative to the web server‘s site root
directory.
The host must be an FTP, HTTP or TFTP server.
<key> The software release install key obtained from HP ProCurve.
remote upgradecheck <ip-address> <url>
Checks whether an upgrade is available for the system at the specified IP address. No key is
required for this operation.
<url> The URL encoded location of the software release to install. The format of the URL is
<protocol>://<host>/<update file> or
<protocol>
://<username>
[:<password>
]@<host>/<update file>
<protocol> can be ftp, http, or tftp.
<username>[:<password>] specifies a username and optional password with
access to the remote site, if required.
<update file> is the filename (including the path) of the software image.
For TFTP or anonymous FTP, the path is relative to the FTP or TFTP root. If a
username and password is required for FTP, then the full path to the update file must
be specified. For HTTP, the path is always relative to the web server‘s site root
directory.
The host must be an FTP, HTTP or TFTP server.
remote upgradestatus <ip-address>
Get the upgrade status of the system at <ip-address>
Wireless Data Privacy Configuration
Wireless Data Privacy is configured and maintained centrally on an Access Control Server or Integrated
Access Manager, but the settings are propagated to and are implemented/enforced by the Access
Controller. The following commands, except for the
show vpn command, are not available on an Access
Controller.
HP ProCurve Secure Access 700wl Series Management and Configuration Guide A-21
