Chapter 5 Problem Solving 266
Correcting Output Quality Problems
The printer prints only part
of a page or document.
The connection has been broken during transmission. If you
move the portable device during transmission, the connection
can be broken. IRDA-compliant devices are designed to
recover from temporary connection interruptions. You have up
to 40 seconds to re-establish the connection (depending on
the portable device being used).
The print job has been
properly sent, but the printer
will not print.
If the connection is broken before the entire print job has been
transmitted to the printer (printing has not yet started), the
printer may not print any of the job. Press J
OB
C
ANCEL
to clear
the printer’s memory. Then, reposition the portable device
within the range of operation described in Printing a Job
on
page 161
, and print the job again.
The FIR status indicator
turns off during
transmission.
The connection might have been broken. Press J
OB
C
ANCEL
to
clear the printer’s memory. Then, reposition the portable device
within the range of operation described in Printing a Job
on
page 161
, and print the job again.
PS print job will not print.
Check the configuration in the PostScript Tab of Windows:
check that Protocol is set to AppleTalk and Binary Data is not
selected.
HP Fast InfraRed Connect Problems (continued)
Situation Solution
