16
STACK menu settings
NOTE • When DUAL is selected for LAMP MODE, the images projected from
the Main and Sub projectors can be different. We recommend setting up the
projectors as follows:
- Select the same image for TEMPLATE and START UP on the Main and Sub
projectors.
- Capture the same image for MyScreen on the Main and Sub projectors.
- Save the same image on MY IMAGE on the Main and Sub projectors.
- Set the same message content for the Messenger function (
Network Guide
→ Messenger Function) on the Main and Sub projectors.
• When DUAL is selected for LAMP MODE, image shift can cause image quality
degradation on the screen. Before adjusting the image position, adjust the
INSTALLATION settings rst because changing the INSTALLATION settings will
affect the image position. (
Operating Guide
→ SETUP menu)
• When ALTERNATE is selected and a malfunction causes the projector's lamp
to turn off, the other projector will automatically start to operate. However the
other projector will not turn on, if the RS-232 cable is disconnected or if AC
power is not supplied.
• When PIN LOCK or TRANSITION DETECTOR on both projectors is set to ON
(
Operating Guide
→ SECURITY menu), neither projector will turn on even if
ALTERNATE is selected. Enter the security code on both projectors and one of
the projectors will turn on.
• When Intelligent Stack is in use, the POWER indicator on the projector
operates differently than normal (
Operating Guide
→ Troubleshooting). When
both the Main and Sub projectors are in standby mode and the ON button on
the remote control or the STANDBY/ON button of the Main projector is pressed,
the Main projector determines which projector to turn on according to the
STACK MODE setting.
- The POWER indicator on the Main projector blinks green while the Main
projector determines which projector to turn on.
- If the Main projector is turned on, the POWER indicator on the Main projector
turns to steady green after lighting up, as normal.
- If the Sub projector is turned on, the POWER indicator on the Main projector
lights orange after the Sub projector is turned on.
- If an error occurs on the Main projector, the Sub projector turns on and the
POWER
indicator on the
Main
projector lights or blinks red.
3.3 Selecting lamp operation mode (continued)
