22
STACK menu settings
Example:
Cover Error:
The lamp cover is open.
Lamp Error:
The lamp will not light up.
Fan Error:
There is a problem with the cooling
fan.
Temp Error:
The temperature of the projector is
too high.
Air Flow Error:
The temperature of the
projector is too high. Verify that the exhaust
vents are not blocked.
Filter Error:
The lter timer counter exceeds
the hours set in the FILTER MESSAGE menu.
(
Operating Guide
→
OPTION menu
→
SERVICE
)
Cold Error:
The temperature around the
projector is too low.
● If you need to turn off a projector in order to x an error condition, turn off
both the projectors so that Intelligent Stack can be started properly when the
projectors are turned on again.
● If the PIN LOCK or TRANSITION DETECTOR security function on both
projectors is set to ON, both projectors will turn on. Enter the security code for
Main rst, then the security code for Sub. If ALTERNATE mode is selected, one
of the projectors will turn off automatically. (
Operating Guide
→
SECURITY
menu
)
● If the PIN LOCK or TRANSITION DETECTOR security function on one of the
projectors is set to ON, it is necessary to enter the security code as follows
when turning on the projector:
- In DUAL mode, both projectors will turn on. Enter the security code for the
projector that is locked by the security function.
- In ALTERNATE mode, if the projector locked by the security function is due
to turn on according to the ALTERNATE mode setting, only that projector will
turn on. Otherwise, both projectors will turn on. Enter the security code for
the projector that is locked by the security function. After the security lock is
released, one of the projectors will turn off if both projectors are turned on.
3.7 Important information for Intelligent Stack (continued)
